Combi or regular boiler: what's the difference?

A regular boiler, also called a heat-only or conventional boiler, heats your radiators and a hot water cylinder. It gets its water from two tanks in the loft. A combi boiler needs no tanks and no cylinder, because it heats mains water as you use it. Regular boilers are common in older homes. Many people switch to a combi to free up space, but it isn't right for every home.

Updated 15/11/2026 · Express Contractors

Got two tanks in the loft and a cylinder in the airing cupboard? Then you most likely have a regular boiler. Read on for how it works, where it differs from a combi, and what switching involves. Every new boiler job we do starts with a free survey, and regular boilers and combis are both on our list. See new boilers for how that works. If your boiler has broken down, see boiler repair. This guide is part of our common boiler problems series. No tanks in your loft? Read combi vs system boiler instead.

What is a regular boiler?

A regular boiler is a gas boiler that only makes heat, while tanks in the loft supply the water. That's why it's also called a heat-only boiler. People call it a conventional or open-vent boiler too. All these names mean the same setup.

A regular boiler works with these parts around the house:

  • A cold water storage tank in the loft. It's the big one, filled from the mains. It feeds the hot water cylinder, and in some homes the cold taps upstairs.
  • A feed-and-expansion tank next to it. It's the small one. It tops up the water in the heating, and gives it room to grow as it heats up.
  • A vented hot water cylinder, often in an airing cupboard. "Vented" means a pipe from the top runs up to the loft and is open to the air.
  • A pump, often in the airing cupboard. On most regular systems it's separate from the boiler.
  • Separate controls, such as a programmer, a room thermostat and a thermostat on the cylinder.

How can I tell if I have a regular boiler?

Two tanks in the loft and a cylinder in a cupboard usually mean a regular boiler. Another clue is the boiler itself. Most regular boilers have no pressure gauge on the front, because the heating isn't under pressure.

If you have a cylinder but no loft tanks, and a gauge on the boiler, it's more likely a system boiler. If there's no cylinder anywhere, it's a combi.

How does a heat-only boiler work?

A heat-only boiler heats water for the radiators and the cylinder, while gravity moves the tap water down from the loft. The higher the tank sits above a tap, the harder the water pushes. Here's the journey, in order.

  1. Mains water fills the big tank in the loft. A float valve shuts it off when the tank is full, much like a toilet cistern.
  2. That tank feeds cold water down into the bottom of the cylinder.
  3. The boiler heats the water in the heating pipes. The pump sends it round the radiators and through a coil inside the cylinder.
  4. The coil warms the stored water, and the hot water rises to the top of the cylinder.
  5. When you open a hot tap, the weight of water from the loft tank pushes hot water out of the cylinder.
  6. The small tank keeps the heating topped up. An open pipe above it lets air out, and gives the water somewhere safe to go if it gets too hot.

What does combi boiler mean?

"Combi" is short for combination boiler: one unit that gives you both heating and hot water. It's fed straight from the cold mains and heats the water as it runs to the tap. So it needs none of the tanks or the cylinder that a regular boiler relies on.

Next to a regular boiler, a combi drops four things: the big loft tank, the small loft tank, the cylinder and the separate pump. The pump moves inside the boiler case. With no small tank to refill it, the heating water is topped up by hand, from a little tap under the boiler called a filling loop.

Safety first

Smell gas? Open doors and windows. Don't use light switches or anything that could spark. Turn the gas off at the meter if you can do it safely. Then go outside and call the National Gas Emergency number on 0800 111 999.

Headaches, dizziness, sickness or a lazy yellow flame? These can be signs of carbon monoxide (CO), a poison gas you can't see or smell. Turn the boiler off, open windows, get everyone outside and call 0800 111 999. See a doctor if anyone feels unwell. Our carbon monoxide advice has more.

Never open the boiler case. Only a Gas Safe registered engineer should take the cover off a gas boiler. The checks in our guides are all ones you can do from the outside.

Regular vs combi boiler: the main differences

A regular boiler stores water in tanks and a cylinder, and a combi stores nothing. That changes your water pressure, the space you lose to tanks, and what happens when the boiler stops.

Part of the systemRegular boilerCombi boiler
Loft tanksTwo: a big cold water tank and a small feed-and-expansion tankNone
Hot waterStored in a vented cylinderHeated as it flows
Tap pressureFrom gravity, so it depends on the tank's heightFrom the mains
Heating waterOpen to the air and topped up from the loftSealed, with a pressure gauge
PumpUsually separate, near the cylinderInside the boiler
Backup for hot waterAn immersion heater in the cylinderNone

Why are there tanks in my loft?

They hold the water a regular boiler system needs. Tanks work well, but they bring a few jobs of their own. A tank in a cold loft can freeze, so it needs insulation round it. It needs a lid to keep dirt out. And an old float valve can stick and let the tank overflow. A combi has none of this to worry about.

Why is my shower weak with a regular boiler?

Because gravity is doing the pushing. A shower upstairs sits only a short way below the loft tank, so the water falls a short distance and comes out gently. Bungalows can be the weakest. Many homes add a shower pump to help. A combi runs at mains pressure, so showers usually feel stronger, if your mains supply is good.

Is a regular boiler better for older homes?

It can be. Older pipes and radiators in an open-vent system have only ever run at low pressure. A combi's heating runs sealed and under pressure. Weak joints or old radiators can start to weep once the system is pressurised. They aren't always a problem, but they need checking first. A big old house that uses lots of hot water at once may also be better off with stored hot water.

What is the immersion heater for?

It's an electric heating element inside the cylinder, with a switch nearby. If the boiler breaks down, you can still heat water with it. It usually costs more to run than gas, so most people use it only as a backup. With a combi, there's no backup. If it stops, you lose heating and hot water together.

How much space does switching to a combi save?

Quite a lot. Both tanks leave the loft, and the cylinder leaves the airing cupboard. A separate pump and its valves often go too. People often switch before a loft conversion, or to get a bedroom cupboard back.

Switching from a regular boiler to a combi

When you switch, the cylinder and both loft tanks come out, and the combi takes over your heating and hot water. This is called a combi conversion, and it's one of the jobs we do. It has more pipework than a straight swap. The new combi doesn't have to go where the old boiler was. Our guide covers putting a boiler in the loft or another room.

  1. A survey checks your mains water pressure and flow. A combi only works as well as the supply behind it.
  2. The old regular boiler, the cylinder and both loft tanks are taken out.
  3. The pipes are changed, so the hot taps are fed from the combi.
  4. The heating becomes a sealed system. It's filled and tested under pressure, to find any leaks.
  5. The combi is fitted, set up and tested, and you're shown how to use it.

A few things change after the switch:

  • A shower pump isn't needed any more. A shower made for low pressure may need a new valve.
  • You lose the immersion heater backup.
  • Two hot taps at once share the combi's flow.
  • An open-vent system often has sludge built up inside. A power flush before the new boiler can help, and we'll tell you if it isn't needed.

There's a middle route too. Some homes swap the loft tanks for a system boiler with an unvented cylinder. That keeps the stored hot water but runs it at mains pressure. We do this switch as well. Our guide to combi vs system boilers explains how that works.

Any make can go in, whichever type you end up with: regular, system or combi. The price is fixed after a free survey, and that's also when we tell you how long the work should take. All our work is guaranteed for 12 months, parts and labour. See our boiler installation page for more.

When does keeping a regular boiler make sense?

Keeping a regular boiler can make sense if your mains supply is weak, or your home needs lots of hot water at once. A combi isn't an upgrade for every home. These are the usual reasons to stay put, and each can be checked at a survey.

  • your mains water pressure or flow is low, so a combi would give weak hot water
  • you have two or more bathrooms in use at the same time
  • your pipes and radiators are old, and might not cope with a sealed system
  • you want to keep the immersion heater as a backup
  • your system works well, and a like-for-like swap is the simplest job

If your regular boiler is getting old, our guide to how long a boiler lasts shows the signs that it's time for a new one. To keep it running well until then, book a yearly boiler service.

When to call a Gas Safe engineer

Call a Gas Safe engineer if your boiler has stopped, or the cylinder won't heat. Book a free survey if you're thinking of switching to a combi. By law, only a Gas Safe registered engineer may work on a gas boiler.

  • the boiler has broken down, or keeps cutting out
  • hot water is spilling from the pipe over the small loft tank
  • the cylinder stays cold, even with the boiler running
  • the pump is noisy, or radiators stay cold
  • you want honest advice on switching to a combi

On regular systems, we also fix the parts around the boiler: the separate pump, zone valves, immersion heaters and shower pumps. A worn-out cylinder can be swapped for a new one. A loft tank that overflows is plumbing work, so see our plumber page. For a breakdown, see boiler repair. For a new boiler or a combi conversion, we start with a free survey.

Other boiler guides

Thinking about a combi? Book a free survey and we'll give you a fixed price.

Common questions

Bob, the Express Contractors mascot, thinking
Are regular, conventional and heat-only boilers the same thing?

Yes. They are three names for the same type. You may also hear "open-vent boiler". All of them mean a boiler that works with a cold water tank in the loft, a small feed-and-expansion tank and a hot water cylinder.

Do I still need my loft tanks if I get a combi?

No. A combi takes its water straight from the mains, so both loft tanks come out when you switch. The hot water cylinder goes too. The loft and the airing cupboard are then free to use.

Will a combi give me better water pressure than a regular boiler?

Usually, yes, if your mains supply is good. A regular boiler relies on gravity from the loft tank, which can feel weak, mainly upstairs. A combi runs at mains pressure. Its flow is shared between taps, though, so two showers at once will feel weaker.

Does a regular boiler have a pressure gauge?

Most don't need one. The heating is topped up by the small tank in the loft, so it isn't under pressure the way a sealed system is. If your boiler has a gauge that reads around 1 to 1.5 bar, you probably have a combi or a system boiler.

Can I still get a new regular boiler?

Yes. Boiler makers still make heat-only boilers, and we fit them. New ones must be condensing boilers, which take back heat from their own fumes. If your home suits a regular boiler, swapping like for like is often the simplest job. A free survey will tell you which type suits your home best. Book a free survey.

Does a combi have to go where my old boiler was?

No. When you switch, the new combi can often go somewhere else, such as a kitchen cupboard. The spot needs a gas supply, a route for the flue outside and a drain for the condensate pipe. These get checked at the survey. See our boiler installation page.

Bob, the Express Contractors mascot, showing a new boiler

Thinking of switching to a combi?

Call us to book a free survey. A Gas Safe registered engineer will check your mains water and your system, and tell you honestly if a combi suits your home.

Call now · 0121 517 0785