Carbon monoxide alarm beeping? What it means and what to do

A loud, repeating alarm means carbon monoxide has been found. Open windows, turn off appliances if it's safe, get everyone outside and call 0800 111 999. A single chirp every 30 to 60 seconds is usually the battery, or the alarm wearing out. Patterns differ between makes, so check your alarm's manual.

Updated 15/11/2026 · Express Contractors

Carbon monoxide (CO) is a poison gas. You can't see it, smell it or taste it. It comes from fuel that isn't burning properly, for example in a faulty boiler. A CO alarm is the only way to know it's there. This guide explains what each beep means and what to do. It's part of our common boiler problems series. If you can smell gas, that's a different problem: see what to do if you smell gas.

What should I do if my carbon monoxide alarm goes off?

Treat a loud, repeating alarm as real, every time. Get fresh air in, turn off any fuel-burning appliances if you can do it safely, and get everyone out of the house. Then call the National Gas Emergency Service on 0800 111 999. The call is free, day or night.

  1. Don't assume it's a false alarm. CO alarms rarely go off for no reason.
  2. Open doors and windows.
  3. Turn off the boiler, gas fire and cooker if you can do it safely. Turn the gas off at the meter if you can.
  4. Get everyone outside into fresh air. Leave the door open behind you.
  5. Call 0800 111 999. If you have oil or solid fuel, call your fuel supplier or a registered engineer.
  6. If anyone feels unwell, call NHS 111. Call 999 for trouble breathing, sudden confusion, collapse or chest pain. Tell the doctor it may be carbon monoxide.
  7. Don't go back in until the alarm has stopped and the emergency service says it's safe. Some alarms take a few minutes to stop after the air clears.
  8. Don't use the appliance again until a Gas Safe registered engineer has checked it.

Some alarms let you press the button to quieten them for a short time. Many won't go quiet when the level is high. Either way, silencing the alarm doesn't make the air safe.

Safety first

Smell gas? Open doors and windows. Don't use light switches or anything that could spark. Turn the gas off at the meter if you can do it safely. Then go outside and call the National Gas Emergency number on 0800 111 999.

Headaches, dizziness, sickness or a lazy yellow flame? These can be signs of carbon monoxide (CO), a poison gas you can't see or smell. Turn the boiler off, open windows, get everyone outside and call 0800 111 999. See a doctor if anyone feels unwell. Our carbon monoxide advice has more.

Never open the boiler case. Only a Gas Safe registered engineer should take the cover off a gas boiler. The checks in our guides are all ones you can do from the outside.

Is it a real alarm, a low battery or the alarm wearing out?

A real alarm is loud and keeps going in a pattern. A low battery or a worn-out alarm gives a short chirp, then goes quiet for a while. Yes, a CO detector beeps for all of these, which is why it can be confusing.

Every make is different. Check the manual, or the label on the back of the alarm. The table shows common patterns.

What you hearWhat it usually meansWhat to do
Loud beeps repeating in a pattern, often with a red lightCarbon monoxide has been foundFollow the steps above straight away
One chirp about once a minuteLow battery, on alarms where you can change itChange the battery. If it's sealed, replace the alarm
A chirp every 30 seconds that a new battery doesn't stopOften the end of the alarm's lifeReplace the whole alarm now. It may no longer sense CO
Two or three quick beeps on a regular cycleA fault or end of life, on some makesCheck the manual, then replace the alarm
A short chirp and a long chirp, repeatingAn early warning of low CO levels, on some modelsOpen windows and get your appliances checked

On FireAngel alarms, for example, four loud beeps with a red flash means CO. One beep a minute with an amber flash means a low battery. Other makes use other patterns, so your manual is the one to trust.

Why is my carbon monoxide alarm beeping every 30 seconds?

A chirp every 30 seconds often means the alarm has reached the end of its life. The sensor has worn out. A new battery won't stop the noise, and the alarm can no longer be trusted to sense CO.

Kidde, for example, says its alarms chirp every 30 seconds once they reach 7 or 10 years old. Look for a "replace by" date on the back or side. If that date has passed, fit a new alarm the same day. Some alarms give two chirps every 30 seconds instead of one.

Why is my carbon monoxide alarm beeping every minute?

A single chirp about once a minute is often a low battery. If your alarm has a battery you can change, put a new one in. Then press the test button to check it works.

Many alarms now have a sealed battery. You can't change it, so the whole alarm needs replacing. Kidde says to replace its sealed alarms within 30 days of the first low-battery chirp.

Why is my CO alarm still beeping after I changed the battery?

If a new battery doesn't stop the beeping, the alarm has usually reached the end of its life, or it has a fault. In both cases, you need a new alarm.

  • Check the battery is the right type and fitted the right way round.
  • Look for the "replace by" date. If it has passed, replace the alarm.
  • Count the beeps and compare them with the manual.
  • If the alarm is loud and keeps going, treat it as a real alarm, not a battery fault.

How long does a carbon monoxide alarm last?

Most home CO alarms last 7 or 10 years. After that the sensor can't be relied on, even if the alarm still beeps when you test it. The "replace by" date is printed on the alarm.

Many newer alarms have a battery sealed inside that lasts the whole life of the alarm. When the life is up, you replace the alarm, not the battery. It's worth writing the date somewhere you'll see it, such as on the boiler manual.

Where should a carbon monoxide alarm go?

Put a CO alarm in every room that has a fuel-burning appliance, about 1 to 3 metres away from it.That means rooms with a boiler, gas fire, wood burner or open fire. Follow your alarm's own instructions, because makers differ a little.

  • Fit it high up. On a ceiling, keep it at least 300 mm (about a foot) from walls and lights.
  • On a wall, place it above the top of any door or window, but a little way below the ceiling.
  • Boiler in a cupboard? Fit the alarm just outside the cupboard, not inside it.
  • An extra alarm in bedrooms and the main living room is a good idea.
  • Keep it away from doors, windows, vents and fans, which can blow the air away from it.
  • Don't put it right above a sink or cooker, behind curtains, or inside a cupboard.

Near the boiler, the short answer is: in the same room, 1 to 3 metres away, and not right above it.

How do I test a carbon monoxide alarm?

Press and hold the test button until the alarm sounds. Do this at least once a month. If it stays quiet, change the battery, or replace the alarm if the battery is sealed.

  1. Find the test button on the front of the alarm.
  2. Press and hold it for a few seconds.
  3. Listen for a loud beep. It should stop when you let go, or soon after.
  4. Check the "replace by" date while you're there.

Dust can block the sensor. Every few months, clean the outside gently with a soft brush or a vacuum nozzle. Don't use sprays, polish or cleaning fluids on it.

Does a carbon monoxide alarm detect a gas leak?

No. A carbon monoxide alarm only senses carbon monoxide. It won't pick up a leak of mains gas or bottled gas (LPG). These are different gases.

Mains gas has an added smell, a bit like rotten eggs, so you can notice a leak yourself. If you smell it, read our guide to the signs of a gas leak and what to do. Some combined alarms have two sensors, one for each gas. The box will say if yours does.

Why would a CO alarm go off?

A CO alarm goes off when a boiler, fire or cooker isn't burning its fuel properly. The usual causes are a fault in the appliance, a blocked flue or chimney, or not enough fresh air in the room. A flue is the pipe that carries fumes out of the house.

Signs that an appliance may be giving off CO:

  • a lazy yellow or orange flame, where it's normally crisp and blue
  • black soot or brown staining on or around the appliance
  • a pilot light that keeps going out
  • more condensation than usual on the windows

In flats and terraced houses, fumes from a neighbour's faulty flue can sometimes get in too. So don't ignore the alarm because your own boiler seems fine.

Carbon monoxide symptoms to watch for

Carbon monoxide can cause headaches, dizziness, feeling sick, tiredness, confusion and shortness of breath. People often feel better when they're away from home. If anyone has these signs, see a doctor and mention carbon monoxide. For the full list, see the NHS guide to carbon monoxide poisoning.

Do I need a carbon monoxide alarm?

If your home has anything that burns gas, oil, coal or wood, you should have a CO alarm. For homeowners in England it isn't a legal duty in an existing home. But the NHS and the Health and Safety Executive both strongly advise one.

Landlords in England have stricter rules. Since 01/10/2022, they must fit a CO alarm in every room with a fixed appliance that burns fuel, such as a gas boiler. Gas cookers are not included. Landlords must also repair or replace an alarm once a tenant reports a fault. We fit both alarms for landlords. See our page on smoke and CO alarms for landlords, which also covers the yearly gas safety check (CP12).

When you buy an alarm, look for BS EN 50291 and a Kitemark on the box. That shows it meets the British safety standard.

After the alarm: repair the boiler or replace it?

If the boiler set off the alarm, a Gas Safe engineer needs to find out why it isn't burning cleanly.It might be a blocked flue, a worn seal, or a part that needs cleaning. Many of these faults can be fixed.

An engineer first runs a thorough check of the boiler. That finds the fault and the parts needed. Then we give you the price before any work starts. Often a boiler repair is all it takes. If the boiler is old and the fault is serious, the honest answer may be replacing the boiler. We'll tell you which makes more sense.

The best way to stop this happening is a yearly boiler service. It checks the boiler is burning safely and that the flue is clear.

When to call a Gas Safe engineer

Call the emergency line first if the alarm is sounding. Then call a Gas Safe registered engineer to check the appliance. Don't use the boiler, fire or cooker until it has been checked.

  • your CO alarm has gone off, even if it has stopped now
  • the flame on the boiler or cooker is yellow or orange
  • there's soot or staining around an appliance
  • the pilot light keeps going out
  • the boiler hasn't had a service in over a year

We're Gas Safe registered and open 24/7. See our gas engineer in Birmingham page for the gas work we do, or get the boiler fixed if it's the cause.

Other boiler guides

Common questions

Bob, the Express Contractors mascot, thinking
Can I turn off a carbon monoxide alarm that is going off?

Some alarms let you press the button to quieten them for a few minutes. Many won't go quiet if the level of carbon monoxide is high. Silencing the alarm doesn't clear the air. Open windows and get everyone outside first. If carbon monoxide is still there, the alarm will sound again.

My CO alarm went off and then stopped. Is it safe now?

Not on its own. The alarm may stop because fresh air came in, but the cause can still be there. Keep the appliance off and call 0800 111 999. Then have a Gas Safe registered engineer check the boiler, cooker or fire before you use it again. Our Gas Safe engineers.

Does a carbon monoxide alarm need to be near the boiler?

It should be in the same room as the boiler, roughly 1 to 3 metres away. Don't put it right above the boiler or inside the boiler cupboard. If the boiler is in a cupboard, fit the alarm just outside it. Your alarm's manual has the exact spacing.

Can I change the battery in a carbon monoxide alarm?

Only if the manual says the battery can be changed. Many alarms now have a sealed battery that lasts 7 or 10 years. When it runs down, you replace the whole alarm. Never try to force open a sealed alarm.

Who do I call first: the gas emergency line or a gas engineer?

Call the National Gas Emergency Service on 0800 111 999 first. The call is free and the line is open all day and night. They make the home safe. After that, a Gas Safe registered engineer finds the fault and repairs the appliance.

Do landlords have to fit carbon monoxide alarms?

Yes, in England. Since 01/10/2022, landlords must fit a CO alarm in every room with a fixed appliance that burns fuel, such as a gas boiler or a wood burner. Gas cookers are left out of this rule. Landlords must also repair or replace an alarm once a tenant reports it as faulty. Safety checks for landlords.

Bob, the Express Contractors mascot, holding a carbon monoxide alarm

Had a carbon monoxide alarm?

Once the gas emergency service has made your home safe, call us. A Gas Safe registered engineer will check the boiler or gas cooker and find the fault. We're open 24/7.

Call now · 0121 517 0785